1). As Kevin stated, diald is for outbound dialing to your isp
2). Go to www.freesco.org and install it on an old 486. You can configure
freesco to act as a dial-in server. Stick that on your LAN and be your own
ISP.
--Joey
Thou spake:
>first, a recap of what I'm trying to do:
>
>I have a cable modem connection to the internet,
>and I'm trying to set up a linux box to answer line 2
>and act as a PPP server, so that it can act as my
>own ISP if I'm traveling, etc.
>
>relevant specs on the comp:
>RH 9 (i'm most familiar w/ rh)
>rpm installed "diald"
>56k V.90 modem on ttyS1
>working internet access via eth0 (I can browse the internet perfectly
>fine)
>it's connected to a Linksys router (dhcp) -> cable modem
>
>(yeah, it's kinda messed up...)
>
>some other info:
>1st: when I run diald, it gives the following error message:
>Incorrectly built binary which accesses errno, h_errno, or _res
>directly. Needs to be fixed.
>should I d/l the source rpm and compile it?
>
>2nd: it doesn't answer the line; I couldn't figure out where to enter
>an init string in the config file
>
>contents of related files (some of these may be way screwed up...):
>/etc/diald.conf:
>
>linkname dialup
>mode ppp
>blocked
>device ttyS1
>initializer 'ATS0=2'
>modem
>crtscts
>local 192.168.2.1
>remote 192.168.2.2
>netmask 255.255.254.0
>proxyarp
>
>
>/etc/ppp/options (x's are my isp's dns server):
>
>auth -chap +pap login modem crtscts proxyarp lock
>ms-dns xxx.xxx.xxx.xxx
>
>
>/etc/ppp/pap-secrets:
>
># Secrets for authentication using PAP
># client server secret IP addresses
>usernamehere * passwordhere
>192.168.2.2
>
>
>if you need more info, or have some insights, I'd appreciate it...
>
>Ciao,
>
>Steve Cardella
>ssc@bertucciinc.com
>
>___________________
>Nolug mailing list
>nolug@nolug.org
-- Joey Kelly < Minister of the Gospel | Computer Networking Consultant > http://joeykelly.net "Democracy is two wolves and a lamb voting on what to have for lunch. Liberty is a well-armed lamb contesting the vote." ___________________ Nolug mailing list nolug@nolug.orgReceived on 06/27/03
This archive was generated by hypermail 2.2.0 : 12/19/08 EST